2009 Ford F150 Oil Capacity

2009 Ford F150 Oil Capacity is a light-duty pickup truck that is part of the F-Series lineup of full-size trucks from Ford Motor Company. It has a maximum towing capacity of 11,300 pounds and a payload capacity of 3,030 pounds. The 2009 F150 is powered by a 4.6 liter V8 engine that requires 5.7 quarts of 5W-20 motor oil for a full oil change. The oil capacity of the 2009 F150 with a 4.6 liter engine is 6.2 quarts.

Oil Change Basics

A regular oil change is essential for keeping your Ford F150 running smoothly. Oil changes help to reduce wear and tear on the engine and also help to increase fuel economy. The oil filter should be changed with every oil change. It is recommended to use a high quality oil filter for longer engine life. You should always use the correct viscosity oil for your engine, in this case 5W-20. A full oil change should be performed every 3,000 to 5,000 miles.

2009 Ford F150 Oil Capacity

The 2009 Ford F150 with a 4.6 liter V8 engine has a total oil capacity of 6.2 quarts. This includes the oil filter which holds approximately one quart. The oil capacity of the 2009 F150 with a 5.4 liter engine is 7.0 quarts. If you are performing a full oil change, you will need to purchase 5.7 quarts of 5W-20 motor oil.

2009 Ford F150 Oil Capacity Check

Before you start the oil change process, it is important to check the oil level. This can be done by running the engine for a few minutes, then turning it off. After a few minutes, open the oil filler cap and check the oil level using a dipstick. The oil should be between the “low” and “full” marks on the dipstick. If the oil level is low, you can add extra oil until the level is between the two marks.

Oil Change Procedure

The oil change process is relatively simple and can be done in a matter of minutes. First, you will need to lift the hood and locate the oil drain plug. The oil drain plug is located on the bottom of the engine near the oil filter. Use a wrench to loosen the drain plug and allow the oil to drain into a drain pan. Once the oil has drained, reinstall the drain plug and tighten it securely.

Next, remove the oil filter. The oil filter is located on the side of the engine and is held in place with a metal band. Use a wrench to loosen the metal band and then carefully remove the oil filter. Clean the oil filter mounting surface and then install a new oil filter. The new oil filter should be installed with a new metal band and tightened securely.

Now you can add the new oil. Add 5.7 quarts of 5W-20 motor oil to the engine. Once the oil is added, replace the oil filler cap and start the engine. Allow the engine to run for a few minutes and then check the oil level with the dipstick. If the oil level is low, add more oil until the level is between the two marks.

Conclusion

You will need to purchase 5.7 quarts of 5W-20 motor oil for a full oil change. It is important to check the oil level before starting the oil change process. The oil change process is relatively simple and can be done in a matter of minutes. Be sure to use a high quality oil filter for longer engine life.